FE EXAM ยท OTHER DISCIPLINES

FE Other Disciplines Practice Questions

Practice FE-style Other Disciplines questions through interactive engineering problems with guided reasoning and detailed solutions.

Interactive problemsโ€ขReasoning explainedโ€ขSolutions included
CHOOSE A TOPIC

Focus your practice.

Each topic groups questions around a specific FE knowledge area. Topic pages become indexable only after they contain a meaningful practice set.

PRACTICE SET

Available questions

Choose a question and solve it before reading the final engineering verdict.

QUESTION01
E-100Materials

The Stronger Material That Made the Heavier Tie Rod

Material A had the higher yield strength, but its density penalty was much larger. After sizing both rods to the same factor of safety, Material B produced the lighter design.

Material Selection Strength To Density5โ€“10 min
Solve โ†’
QUESTION02
E-099Materials

The Wire That Had 0.17 Ohm, Not 170

The resistivity formula was correct, but 2 mmยฒ was treated as 2ร—10^-9 mยฒ instead of 2ร—10^-6 mยฒ. The wire resistance was 0.17 ohm.

Electrical Resistivity5โ€“10 min
Solve โ†’
QUESTION03
E-098Materials

The 2 m Bar That Grew 2.3 mm, Not 1.15

The thermal strain was correct, but it was applied as if the bar were only 1 m long. The 2 m bar expanded 2.3 mm.

Linear Thermal Expansion5โ€“10 min
Solve โ†’
QUESTION04
E-097Materials

The Alloy That Was 40% Beta, Not 57%

Dividing the overall composition by the beta composition gave 57%, but phase fractions come from tie-line segment lengths. The beta fraction was 40%.

Lever Rule Phase Fractions5โ€“10 min
Solve โ†’
QUESTION05
E-096Engineering Economics

The Risky Project Worth $52,000, Not $35,000

The outcomes were not equally likely. Probability-weighting gives an expected value of $52,000, not the simple average of $35,000.

Expected Monetary Value5โ€“10 min
Solve โ†’
QUESTION06
E-095Engineering Economics

The Process Choice That Broke Even at 10,000 Units, Not 5,000

The fixed-cost difference was correct, but break-even depends on the difference in variable costs. The correct crossover is 10,000 units.

Break Even Analysis5โ€“10 min
Solve โ†’
QUESTION07
E-094Engineering Economics

The Upgrade Worth $3,675, Not $25,000

Undiscounted cash flows suggested a $25,000 gain; discounted NPV is about $3,675.

Present Worth5โ€“10 min
Solve โ†’
QUESTION08
E-093Safety Health Environment

The Relief Valve That Saw 480 N, Not 560

The vessel pressure was 700 kPa absolute, but the valve disk also had atmospheric pressure acting on the opposite side. Net pressure force depended on the 600 kPa differential.

Pressure Difference Force On Valve5โ€“10 min
Solve โ†’
QUESTION09
E-092Safety Health Environment

The Source That Fell to 30, Not 60

Eighteen hours represented three half-lives, not two. A 240-unit rate therefore fell to 30, not 60.

Radioactive Decay Half Life5โ€“10 min
Solve โ†’
QUESTION10
E-091Safety Health Environment

The Confined Space That Needed 18 mยณ/min, Not 1,080

Six air changes per hour sounded like 1,080 mยณ/min when the hour-to-minute conversion was skipped. The required flow was 18 mยณ/min.

Confined Space Ventilation Air Changes5โ€“10 min
Solve โ†’
QUICK ANSWER

How do I practice FE Other Disciplines questions?

Choose a topic, solve the problem before seeing the conclusion, and use the final reasoning trail to identify where your original assumption was supported or needed revision. The goal is not only to reach the answer, but to understand the engineering check behind it.